EdgeStar CWD1510W El manual del propietario descargar pdf (Pagina 13)

INSTALLATION

Connect inlet pipe

Connect the inlet pipe as indicated in the figure below.

Connect the hot inlet valve fo the hot wafer tap and cold inlet valve fo

the cold wafer tap.

............... i!!;4

,i' _i__

Install inlet pipe

Connect the elbow fo the inlet valve af the backside of washing machine

and fasten if fuming clockwise. Connect the other end of inlet pipe fo the

tap and fasten the pipe tightly clockwise.

Note: After connection, if there is any leakage from hose, then repeat the steps fo

connect inlet pipe. The most common type of tap should be used fo supply wafer.

If tap is square or too big, a new tap is required.

EdgeStar Washer/Dryer Combo 8

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Sin comentarios

EdgeStar CWD1510W El manual del propietario Pagina 13