EdgeStar HZB- 12 Manual de usuario descargar pdf (Pagina 6)

SMITH Manufacturing 1-954-941-9744 www.SmithMfg.com

FS150

VERSION 5/2014

MAINTENANCE CHECK LIST

Before beginning servicing on any

FS150 unit, DISCONNECT FROM

AIR SUPPLY SOURCE

• Check all fasteners and re-tighten,

since the machine will vibrate the

fasteners loose if they are not secured.

Use locktight.

• Clean drum housing regularly to prevent

material buildup.

• Inspect drum, and shafts for damage

and replace as needed.

• Regularly lubricate grinder with a

suitable pneumatic motor lubricating oil.

Preferably one that incorporates a rust

inhibitor.

• Check hose and ttings regularly for

wear or leaks, replace if necessary.

• Check all fasteners and re-tighten,

since the machine will vibrate the

fasteners loose if they are not secured.

Use locktight.

SAFETY GUIDELINES

-ELECTRIC-

• Accessories must be rated for at least the

speed recommended on the tool warning label.

Wheels and other accessories running over

rated speed can y apart and cause injury.

• Hold tool by insulated gripping surfaces when

performing an operation where the cutting tool

may contact hidden wiring or its own cord.

Contact with a “live” wire will make exposed

metal parts of the tool “live” and shock the

operator.

• NEVER use tool with wood cutting blades or

other sawblades. Such blades when used on

a polisher frequently kick and cause loss of

control leading to personal injury.

• Hold the tool rmly and keeps hands away from

rotating parts.

• Make sure the abrasive disc or wool bonnet is

not contacting the workpiece before the switch

is turned on.

• When sanding metal surfaces, watch out for

ying sparks. Hold the tool so that sparks y

away from you and other persons or ammable

materials.

• Do not leave the tool running. Operate the tool

only when hand-held.

• Do not touch the workpiece immediately after

operation; it may be extremely hot and could

burn your skin.

• Check that the workpiece is properly supported.

• Pay attention that the wheel continues to rotate

after the tool is switched off. Check hose and

ttings regularly for wear, replace if necessary

• This tool has not been waterproofed, so do not

use water on the workpiece surface.

• Ventilate your work area adequately when you

perform sanding operations.

• Use of this tool to sand some products, paints

and wood could expose user to dust containing

hazardous substances. Use appropriate respi-

ratory protection.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Comentarios a estos manuales

Sin comentarios

EdgeStar HZB- 12 Manual de usuario Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas productoras de hielo EdgeStar HZB- 12